• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Fiat 500 Replacement Key Fob

It may be time to replace the battery if the 500 remote key fob isn't working. If you replace the battery and it's still not working the issue could be somewhere else.

At United Locksmith, we specialize in making new fiat 500 key keys for old cars. We have the tools as well as the parts needed for this service.

Dead Coin Battery

The most common reason why your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The key fob comes with a coin cell battery which will quickly drain in the event that it is not frequented enough. If your remote starts to show signs of loss in range or stopped functioning, then the battery may be dead.

The battery inside the key fob is held in place with metal retaining clips. If the clips are not secure, they could cause contact problems that will prevent your remote from receiving power. Use a flathead screwdriver break open the retaining clip and then remove the old battery. Choose a battery that is the same size, voltage and specification as the original.

Exposure to water can cause the key fob to corrode, or even become damaged. Even a short shower in soapy water can harm the electronic chip in. It's best to keep your key fob in a dry place.

Water Damage

Water damage could be the reason behind your key fob's inability to function properly. Key fobs have rubber seals to protect them from being damaged by a light rain or a splash of water, but it is very important to keep your car keys safe from the ocean, pool, and washing machine!

The key fob contains an electronic chip that sends an immobilizer system of your vehicle. This is the reason why your 500 can start or lock, but when the chip becomes wet, it will no longer work.

You can clean the internal electronics of your key fob using isopropyl alcohol, or an electronic cleaner to see whether they're still functioning. It is recommended to replace the key fob when it is submerged in salt water rather than try to repair it yourself.

Although a replacement fob may cost a bit of money, it is much less expensive than paying for your fiat replacement car keys 500 to be towed to a dealership and fixed! You can also do it yourself with a few simple steps. Just ensure you have the correct battery type before you attempt to open your key fob. This task is far simpler than it appears and you can find step-by-step directions online for almost any key fob in your car.

Faulty Chip

The chip inside the key fob communicates with the vehicle's immobiliser to ensure that your car is only able to start when the correct key is used. If the chip is damaged or damaged in any way it will not start.

A chip that is defective can happen due to a variety of reasons but most commonly due to water damage or the battery being dead. Regardless of the reason, it is a good idea to leave this task to a locksmith, as they can replace the chip for you quickly and at a reasonable cost.

If your key fob does not work after exposure to clean tap or rain water, remove the battery. Wipe down the electronic component using a paper towel. If the key fob will not work, there's a chance that it has a fried component and needs to be replaced.

Some people will go to their dealer when they are in need of an entirely new Fiat key fob, however this can be a very expensive option. If you are looking for a low-cost solution to have your Fiat key fob repaired, look no further than United Locksmith. We have the tools and experience necessary to repair your fiat car keys Cut key fob in a quick and professional manner.

Faulty Receiver Module

Fiat key fobs send a signal up 50 feet to the vehicle, which will unlock and close the doors (and start the vehicle if it has automatic transmissions). There are a variety of reasons why the fob might not function. This could be due to a dead coin battery damaged by water or worn buttons, a receiver module issue or signal interference, or an electronic chip malfunctioning.

If the fob has been in a pocket that has been subject to extreme trauma, like falling on hard floor or being washed in the washing machine, it may not be able to communicate with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept a signal from a genuine key and not another.

You'll need to replace the fob if this occurs. A professional locksmith will take care of the entire key replacement process including programming a new one for your 500. They can even provide an clone fob that performs just like the original (and costs only a fraction of what it would cost).